ANT-433-PW-QW DATA SHEET
Product Dimensions Description
Features
Electrical Specifications
Ordering Information
Designed for permanent attachment, PW Series 1/4-
wave whips give outstanding performance in a rugged
and cost-effective package. The antenna is attached by
placing its base through a 1/4” hole in the product and
securing it with a nut or by threading it into a PEM-style
insert. This method of attachment is highly secure and
saves the cost of an antenna connector. The antenna is
fed through the base with RG-174 coax cable, which may
be soldered directly to the board or attached using a 50-
ohm connector. Standard cable length is 8.5”. Custom
lengths and terminations are available by special order.
6.81”
(173.0)
0.24”
(6.0)
0.51”
(13.0)
2.05”
(52.0)
0.18”
(4.5)
0.31”
(7.8)
End View
0.57”
(14.5)
* Requires proximity ground plane
Electrical specifications and plots measured on 4.00” x 4.00” reference ground plane
0.25”
28 TPI
Rev 07-22-08
Typical VSWR
Antenna Factor 159 Ort Lane Merlin, OR 97532 www.antennafactor.com
541-956-0931 (phone) 541-471-6251 (fax)
VSWR Graph
• Low cost
• Outstanding performance
• Omni-directional pattern
• Wide bandwidth
• Flexible main shaft
• Rugged & weatherized
• Integral 8½-inch RG-174 coax cable
• Use with plastic* or metal enclosures
• Center Freq. 433MHz
• Bandwidth 80MHz
• Wavelength 1/4-wave
• VSWR <1.9 typ. at center
• Impedance 50 ohms
• Connection Case-mount
• Cable 8½-inch RG-174 coax
• ANT-433-PW-QW